This forum is archived, go to the new forum!

This is the old fritzing discussion forum. Search it for valuable information from 2009 to 2015.

SMD stencil for reflowing from Fab?

Frode Lillerud 5 years, 5 months ago

Frode Lillerud

Hi, I wish the fab-service also offered to sell SMD stencils for the boards we order through them.

 

Would that be possible?

André Knörig 5 years, 4 months ago

André Knörig

Hi Frode,

We had already talked to our manufacturer about this, but it wasn't a feasible price. There are cheaper methods to do this, but we haven't found a good offer for this yet. We'll look into that again, though!

Frode Lillerud 5 years, 4 months ago

Frode Lillerud

Ok, thanks!