This forum is archived, go to the new forum!

This is the old fritzing discussion forum. Search it for valuable information from 2009 to 2015.


JohnBunyan 4 years, 11 months ago

Tried the Ping Pong Matrix but the potentiometers will not fit into the breadboard. I didn't want to bend or cut off the 2 metal parts that prevent it going on the board. Any suggestions?   

schnee huhn 4 years, 7 months ago

schnee huhn

uff..same problem here. did you found a resolution??

Markus1811 4 years, 7 months ago

the only solution i see is to bend the two metal parts away... that is what i did... i do not expect to use the parts from the creator kit in an production like environment in the future... i handle them as experimental parts. can send picture of the potentiometer if wanted ;-)