This forum is archived, go to the new forum!

This is the old fritzing discussion forum. Search it for valuable information from 2009 to 2015.

No where to grab LEDs on PCB designer?

sirkerrald 4 years, 11 months ago

I'm trying to move about 48 LEDs around on a charlieplexed matrix and it's nearly impossible. All I can grab are wires or anodes/cathodes. Is there a trick to this? They all seem to be stacked. 

 

 

nyro2011 4 years, 11 months ago

The only trick i know is to zoom in and place the coursor over the center of the LED until there is only an arrow without the wire symbol.

Maybe you can try that without zooming in that close baut that takes a Lolot of patience.

Sorry for the bad spelling, I am on mobile and not a native später

speaker