electronics made easy
This is the old fritzing discussion forum. Search it for valuable information from 2009 to 2015.
I have a strange issue where I have inadvertently placed several pads (sparkfun pin header / luxeon-pad) on top of each other.
Now I have no way to separate them. I can't for the life of me figure out how to select only a single one.
When I click on the top one, it immediately starts creating a new trace. If I click and drag around them to select, it selects all of them.
What can I do, short of deleting them and starting over?
Well, my (very painful) woraround is to right-click on the top pad and select Rotate 90. This makes the top and bottom stick up just enough that I can click and grag a corner to select it and move it out of the way. Rinse, repeat. Surely there's a better way??