Fritzing

This project is an example of remotely controlled car via WIFI. The circuit is based on ESP8266, and the software is written in the Arduino IDE. As an engine driver, I used the L298N. The vehicle's speed is controlled by PWM in the range of 0 to 1023. Digital control offers more possibilities than the usual controller. I also added a RGB LED as light and buzzer as a horn.

• 

This project is an example of remotely controlled car via WIFI. The circuit is based on ESP8266, and the software is written in the Arduino IDE. As an engine driver, I used the L298N. The vehicle's speed is controlled by PWM in the range of 0 to 1023. Digital control offers more possibilities than the usual controller. I also added a RGB LED as light and buzzer as a horn.

Step 1: Components

Components that I used in this project.

• ESP8266
• L298N
• Buzzer
• ws2812b
• RC car
• Some wires

 

See more:

DIY WIFI RC car with ESP8266 and Arduino IDE