Fritzing

Just a quick board to connect the Nano with the Easydriver. This was set up to control my magnetic loop antenna using a 2.8V stepper and the L298N H-Bridge controller..   I used open hardware from various sites to make my life easy.   # WS2812 5050 RGB Strip for motor speed indication. # Encoder for direction/speed sellection etc # Buzzer for conformation of action. # Single 5v supply (if using apropriate motor) # Breakout pins for memory button exspanion  

• 
• 
• 

All credits go to the following:

http://www.bristolwatch.com/arduino/easy_driver.htm

 

Brainy-Bits on Youtube: 

https://youtu.be/mvGV6fs19hU